Articles
Articles
Permco offers a variety of Vane Pumps and Motors. Please visit the Products Page to view our available Vane Series.
Mon, 24 Feb, 2020 at 11:15 AM
1. After removing cartridge from the vane pump, place cartridge on a clean work area with pressure plate facing down. 2. Locate and remove 2 retaining scre...
Mon, 24 Feb, 2020 at 11:16 AM
Please see attached quick reference on how to change the port orientation of an EVO Vane unit.
Mon, 24 Feb, 2020 at 11:16 AM
A thru-drive is a single or triple PT6C, PT6D, PT6E pump with the availability to add an additional pump onto the back of it (similar to a piggyback.) This ...
Mon, 24 Feb, 2020 at 11:21 AM
Industrial Vane Pumps are designed to run at constant speeds, commonly for indoor use where noise levels are an issue, and driven by an electric motor at 18...
Mon, 24 Feb, 2020 at 11:23 AM
To easily identify Permco EVO Vane Port Locations, please reference the following images for Single, Double, and Triple Vane Units. Legend: S = Suction Por...
Mon, 24 Feb, 2020 at 11:23 AM
The PM4S Vane Motors are recommended when system back pressure is over 2000 PSI and the motor exceeds 2000 RPM. Also if fluid viscosity is less than 115 SUS...
Mon, 24 Feb, 2020 at 11:24 AM
The PT7 Series vane pump was designed after the PT6 Series and introduced for two primary reasons: to improve the pressure capabilities & to reduce the ...
Mon, 24 Feb, 2020 at 11:24 AM
Please see attachment for PM$D Engineering Bulletin.
Fri, 28 Feb, 2020 at 1:01 PM