Permco Provides You the Answers for Hydraulic Gears and Pumps

Support Center

How to change EVO Vane Cart Kit Rotation?

Last Updated: Feb 07, 2013 03:18PM EST
1. After removing cartridge from the vane pump, place cartridge on a clean work area  with pressure plate facing down.
2. Locate and remove 2 retaining screws, then lift off rear port plate.
3. Remove dowel pins.  (Note: Dowel pin locations will change)
4. Lift cam ring off rotor assembly and rotate 180° on the horizontal axis.
5. Install the cam ring back over the rotor assembly.
6. Place dowel pins in new positions and reinstall rear pressure plate.
7. Reinstall retaining screws in their new position and test rotation of rotor assembly.

**CAUTION: When lifting cam ring off rotor assembly, vanes can fall out of rotor**
***Not applicable for PT6E or PT7E***


Contact Us

orders@permco.com
http://assets2.desk.com/
false
permco
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete